Average Reviews:
(More customer reviews)It took me a little longer to set up than most. I mounted it on a 20 year old duracraft 10" by making some custom brackets. To mount this fence your table should be 27.25" +- .75" deep and the mounting holes for the rails should be 16" apart, 8" on each side of the blade and 1-3/16" from the top of the table. If your saw falls within these dims you should have it up and running within 20 minutes. It took me about 5 hours to mill aluminum table extensions for mine and get it mounted.
About the only thing I would change with the fence is that the indicator window rides about .5" above the tape on the rail -- this allows for too much error depending on your line of sight. I have mine set up so I can cut within +-.007" by only using the scale on the rail (that's right, +-1/128") but if someone else used it they might not know which eye to close and where to hold their head. :-) Of course, with the micro adjust you could probably cut within .001" with a couple setup cuts.
All in all I was amazed at the accuracy, ease of use, and simplicity of this fence. After I ordered it I wondered if I should have ordered the incra TS III because it has multiple rails and should hold square better. Once I got it and set it up, I think this fence is just right for my saw and it holds square perfectly. Maybe I'll try out the incra design on my router table.
Click Here to see more reviews about: Vega PRO 50 Table Saw Fence System: 42-Inch Fence Bar, 50-Inch to Right
Get 26% OFF
0 comments:
Post a Comment