Average Reviews:
(More customer reviews)The Delta Versa-feeder was easy to assemble. The only problem encountered was that the overarm end was slightly mushroomed and required light filing to attach to the pivot ball. This appeared to be a shipping problem which could easily be corrected with Delta placing a protective cap on the ends.I have run 4' long 7/8" oak through the Versa-Feeder on a Delta Unisaw and it performed well. It made easy work of a tedious and some-what dangerous job. I am also going to use it on a Walker-Turner 3/4" shaper where it will usually be mounted. The drawback to the Versa-Feeder I feel would be in it's pivot ball and overarm design. It makes it harder to fine tune the Versa-Feeder to the stock and machine it is mounted on. But at better than 1/2 the price of Delta's 1/4 hp model the value is in the savings. I feel with more practice it will become easier for me to set up.
Click Here to see more reviews about: DELTA 36-865 Versa-Feeder 1/8 Horsepower 10 to 46 Feet Per Minute Variable Speed Stock Feeder, 115-Volt 1 Phase
The DELTA 36-865 Versa-Feeder 1/8 HP 10 to 46 Feet Per Minute Variable Speed Stock Feeder features a 115V, 0.125 HP reversing motor with a scaling feed rate of 10-46 feet per minute for maximum versatility. The micro-adjustable support arm can be attached to machines a variety of ways via mounting connections located at both ends of the arm. Position the feeder exactly as you need it using the swivel jointed unlocking handle. A 3-inch diameter non-marring wheel ensures smooth feeding while the adjustable base-mounting bracket can be fitted to most operating machines for maximum usability.
Get 49% OFF
0 comments:
Post a Comment