Showing posts with label power edger. Show all posts
Showing posts with label power edger. Show all posts

Swisher TR45A Trim Rite Edger with 4.5 HP Briggs & Stratton Sprint Engine Review

Swisher TR45A Trim Rite Edger with 4.5 HP Briggs and Stratton Sprint Engine
Average Reviews:

(More customer reviews)
I used it one time and want to sell it. With only one wheel on the far right side of the blade it tilts towards the blade when you lift the handle to go around a curve in my driveway. it then digs into the concrete or the lawn and tears it up. I purchased this thinking it would be as good as the Trim Rite trimmer I've owned for almost 20 years but it's not.

Click Here to see more reviews about: Swisher TR45A Trim Rite Edger with 4.5 HP Briggs & Stratton Sprint Engine

If you want a manicured look around sidewalks and driveways then the Trim-Rite edger is the machine for you. This edger features an adjustable cutter head to adapt a variety of angles. U.S.A.

Buy NowGet 1% OFF

Click here for more information about Swisher TR45A Trim Rite Edger with 4.5 HP Briggs & Stratton Sprint Engine

Read More...

Troy-Bilt TB554 9-Inch 158cc Briggs & Stratton 500 Series Gas-Powered Lawn Edger with Curb Wheel Review

Troy-Bilt TB554 9-Inch 158cc Briggs and Stratton 500 Series Gas-Powered Lawn Edger with Curb Wheel
Average Reviews:

(More customer reviews)
I just purchased a Troy-Bilt 4HP triple blade Edger at Lowes yesterday. The unit edges well. We have a long driveway (500 ft.) with lots of curves, and I believe we can keep grass from growing into the driveway with this unit. On the downside, I've only tried to start it a couple times, with poor success both times. Right out of the box, it took about 15 pulls to start the first time. After running for several minutes, I released the safety bar, which kills the engine (there is no clutch to stop the blade... releasing the bar kills the engine). Then, with the engine already warm from just runing, it took another 10-15 pulls to re-start. The unit has no choke, only a primer bulb which I believe contributes to hard starting. Zapped by "big brother" again!
UPDATE: After using this edger for about 2 months, I believe my rating to be a little to hard. The problem is that the number of pump primes needed to start the machine cold is considerably more than stated in the instructions, at least on my edger. The instructions written on the edger say to pump it 3X. The instructions in the users manual say to pump the primer 6X. By experience, I've learned that if I pump it 12X, it usually starts on the first pull. As long as I know this, it is not really a problem. Our driveway is 450 feet long, so requires 900 feet of edging total (because there are two sides). The edger does a good job. However, it will only dig a maximum of 2 1/4". This is lower than other edgers I've used. Because the edge of our drive is higher than the ground, if I edgw with the wheels on the hard driveway surface per the instructions, I can only dig less than an inch deep. If I want to edge deeper (up to 2 1/4"), I have to have the wheels on the ground. This is contrary to the instructions, but works. Because I'm satisfied with the edger, and have overcome the initial starting problem, I would change my rating to a 4.0 if amazon allowed that.

Click Here to see more reviews about: Troy-Bilt TB554 9-Inch 158cc Briggs & Stratton 500 Series Gas-Powered Lawn Edger with Curb Wheel

TROY-BILT" EDGER/TRENCHER 4.0HP B&S 9" steel blade with plastic blade guard 6 position from 1/4" to 2" Trenching kit included 2 year limited warranty Boxed

Buy Now

Click here for more information about Troy-Bilt TB554 9-Inch 158cc Briggs & Stratton 500 Series Gas-Powered Lawn Edger with Curb Wheel

Read More...

McLane 101 9-Inch Gas Powered Lawn Edger Review

McLane 101 9-Inch Gas Powered Lawn Edger
Average Reviews:

(More customer reviews)
Excellent edger. Minor assembly. Easy to start. Engine has sufficient power. Blade makes a nice cut. Blade can be tilted for an angled cut. You can stop the blade without having to shut off the engine.
I'm glad I bought it.

Click Here to see more reviews about: McLane 101 9-Inch Gas Powered Lawn Edger



Buy Now

Click here for more information about McLane 101 9-Inch Gas Powered Lawn Edger

Read More...

McLane 801 4.75 GT/3.5RP 9-Inch Gas Powered Lawn Edger With Ball Bearing Wheels Review

McLane 801 4.75 GT/3.5RP 9-Inch Gas Powered Lawn Edger With Ball Bearing Wheels
Average Reviews:

(More customer reviews)
Assembly is easy.
Engine is easy to start and runs well.
Unit cuts properly and is easy to use BUT ......
the belt pulley on the cutter head keeps coming off of the shaft.
It appears to be a friction fit.
There is no set screw or mechanical device to keep the pulley on the shaft.
I have reinstalled it 3 times but it keeps coming off.
I will have to call the factory and find out how to get it fixed.
Other than this defect it is a good unit.
UPDATE:
I contacted the factory and they promptly sent a new cutter head assembly.
Very simply installed in 5 minutes with minimal tools.
Now it works great!
I now rate it 5 stars.


Click Here to see more reviews about: McLane 801 4.75 GT/3.5RP 9-Inch Gas Powered Lawn Edger With Ball Bearing Wheels



Buy Now

Click here for more information about McLane 801 4.75 GT/3.5RP 9-Inch Gas Powered Lawn Edger With Ball Bearing Wheels

Read More...