Average Reviews:
(More customer reviews)Problems on assembly:
1) Center hole on cast iron base @ both ends was not centered + did not line up to the leg cross brace. Fix: used air grinder to grind cross brace hole wider.
2) Instructions for the installing the adust. feet were vague. Just says use "provided hardware". Fix: used my incredible powers of observation and deduction to determine what goes where.
3) The leg cross brace opposite of motor has an interference problem w/switch box. Fix: ground the cross brace to form a notch to clear switch box.
Usage:
1) table for vertical cuts is flimsy. Only single support underneath - needs 2. could not level table since there is no adjustment.
2) Adjustment of eccentric bearing requires a thin wrench to fit between bearing + support casting.
3) The blade covering has to be put on "just right" otherwise interference with the stop bolt occurs.
4) When moving the miter vise plate, the hold down bolt interferes w/the screw that holds the scale strip. Loosening the bolt enough will get past the interference unless the angle you want is right where the interference occurs.
In general:
The motor has enough power for cuts. I've been cutting 4130 .125 steel and the motor never bogged down. Horizontal cuts is this machines best use. vertical cutting leaves a lot to be desired but this could be because the blade's tooth pitch did not match up to the metal type. But,as stated above, the table doesn't help.
Click Here to see more reviews about: Jet 414458 HVBS-56M 5-by-6-Inch 1/2 HP Horizontal/Vertical Bandsaw
The Jet 5-by-6-Inch 1/2-Horsepower Horizontal/Vertical Band Saw features an exclusive heavy-duty 14-gauge stand and was designed for a multitude of different professional metal cutting applications. It also comes with large diameter wheels and a built-in handle that allows for easy transportation. The front legs include adjustable leveling pads for ensured cutting precision. For added durability and longevity, the saw features a ball bearing supported blade wheel, fully adjustable ball bearing blade guides, and a heat-treated and ground steel worm gear with bronze drive gear. There are 3-blade speeds to choose from, and the saw also comes with an automatic shut-off for added for safety.
0 comments:
Post a Comment